Hydraulic Spline Rolling Machine

40 Ton Hydraulic Spline Rolling Machine:

Hydraulic Thread Rolling Machine

We have developed high capacity b>(40 ton) Hydraulic Spline Rolling Machine with force feeding system of rolling to roll tractor and truck axles with flange of Ø 150 at one end.

Components up to 2.5 module can be rolled in thisSpline Rolling Machine.

Specifications of our 40 ton Hydraulic spline Rolling Machine
Maximum Roll diameter 200 mm
Bore size 69.85 mm
Max. Roll width 130 mm
Max. Diameter of the job 70 mm
Max. Pitch 2.5 module
Min. Job diameter 10 mm
Max. Spline length 150 mm std. (higher available)
Max. Job length 650 mm between centre
Max. Swing of the Job (Flange Dia) 190 mm
Roll Shaft RPM Infinitely variable 0-50 RPM std.
Gearbox Hardened and ground helical gears(no worm & worm gears)
Lubrication Centralized lubrication with PLC controls
Electrical Control PLC with 24 Volts DC
Slide movement Both roll shafts move towards center on Imported Linear Guides, hence the job is centrally placed always.
Depth/Size control With positive arrangement
Rolling cycle Spline Rolling –Force Feeding System of rolling, Plunge Rolling Cycle.
Connected load (approx.) 17 HP approx.)
Floor space 2.5 x 2.5 meters.
Weight of the machine 3.75 tons approx.
Construction Machine grade cast iron body mounted on stress relieved welded body, single piece construction, epoxy coated hydraulic and coolant tank inside the machine.
Electricity The total consumption of electricity will be less on our machine, because of higher efficient gearbox and Variable Speed Drive, for which lower HP motors are used. This will pay back your investment in a short period.
The Hand of JESUS has done this