Hydraulic Thread Rolling Machine

20 Ton Hydraulic Spline Rolling Machine:

Hydraulic Thread Rolling Machine
Hydraulic Thread Rolling Machine

Components up to 1.3 module can be rolled in this machine.

Specifications of our 20 ton Hydraulic Spline Rolling Machine
Maximum Roll diameter 200 mm
Bore size 54 mm std./69.85 mm
Max. Roll width 125 mm
Max. Diameter of the job 50 mm
Max. Pitch 4 mm
Max. Spline 1.25 mod. (higher with helix)
Min. Job diameter 5 mm
Max. Spline length 100 mm std. (higher available)
Roll Shaft RPM Infinitely variable 0-50 RPM std.
Gearbox Hardened and ground helical gears(no worm & worm gears)
Lubrication Centralized lubrication with PLC controls
Electrical Control PLC with 24 Volts DC
Slide movement Both roll shafts move towards center on Imported Linear Guides, hence the job is centrally placed always.
Depth/Size control With positive arrangement
Rolling cycle Spline Rolling –Force Feeding System of rolling, Plunge Rolling Cycle.
Connected load (approx.) 9.5 HP approx.)
Floor space 1.75 x 1.75 meters.
Weight of the machine 2.6 tons approx.
Construction Machine grade cast iron body mounted on stress relieved welded body, single piece construction, epoxy coated hydraulic and coolant tank inside the machine.
Electricity The total consumption of electricity will be less on our machine, because of higher efficient gearbox and Variable Speed Drive, for which lower HP motors are used. This will pay back your investment in a short period.
The Hand of JESUS has done this